Frequently Asked Questions > RoboCut (8 entries)
Here you will find Frequently Asked Questions about USG Robotics and its products. If you do not find the answer to your question here, please feel free to contact us.
Search the FAQ for entries containing:
-
Environment - Robots, especially those built by Kuka Robotics , are built for industries with much harsher environments than the dust and water we in the stone industry subject it to. ...
-
Using a Vision System ( RoboEyes ) allows you to capture a photograph of the cutting area. It shows the actual slab in place on the cutting table. You do NOT ...
-
Using both a waterjet and a saw blade is beneficial for several reasons: Material Usage - When a saw blade cuts through a piece of stone it must pass ...
-
Utilizing the dual-table system will increase your productivity and throughput. The Robot is centered between the two tables. This creates a completely open table while RoboCut is cutting ...
-
RoboCut , both the software and the Robot itself, are connected to the internet. If a problem should arise there is usually a simple solution. Almost all issues are handled via ...
-
Training for RoboCut is typically one week. In most cases your operator will be comfortable enough to start cutting on their own after a day or two. We will extend training ...
-
RoboCu t has the smallest footprint out of any WaterJet/Saw. It is typically 22'x14' for the Robot and two tables with the control panels, water intensifier and garnet hopper offset. However, ...
-
Please take a look at the image below. You can click on the thumbnail to enlarge it.
Copyright © 2009-forever, USG Robotics Inc.